Kysymykset on aika yksinkertaisia ja asennus on suht. helppo.
HUOM, system nameen kannattaa antaa tämän clusterin nimi, eikä kytkimen nimi, kuten itse tein.. tosin alla on ohje miten se muutetaan jälkikäteen.
Enter the configuration method. (console/gui) ? console
Enter the setup mode; setup newly or restore from backup. (setup/restore) ? setup
You have chosen to setup a new Fabric interconnect. Continue? (y/n): y
Enter the password for "admin":
Confirm the password for "admin":
Do you want to create a new cluster on this Fabric interconnect (select 'no' for standalone setup or 'yes' if you want this Fabric interconnect to be added to an existing clus
Enter the switch fabric (A/B) []: A
Enter the system name: ucs1
Physical Switch Mgmt0 IPv4 address : 10.0.0.4
Physical Switch Mgmt0 IPv4 netmask : 255.255.255.0
IPv4 address of the default gateway : 10.0.0.1
Cluster IPv4 address : 10.0.0.3
Configure the DNS Server IPv4 address? (yes/no) [n]: y
DNS IPv4 address : 10.0.0.100
Configure the default domain name? (yes/no) [n]: y
Default domain name : test.net
Following configurations will be applied:
Switch Fabric=A
System Name=ucs1
Physical Switch Mgmt0 IP Address=10.0.0.4
Physical Switch Mgmt0 IP Netmask=255.255.255.0
Default Gateway=10.0.0.1
DNS Server=10.0.0.100
Domain Name=test.net
Cluster Enabled=yes
Cluster IP Address=10.0.0.3
Apply and save the configuration (select 'no' if you want to re-enter)? (yes/no): yes
Applying configuration. Please wait.
Configuration file - Ok
Sen jälkeen toinen kytkin konsolilta:
Enter the configuration method. (console/gui) ? console
Installer has detected the presence of a peer Fabric interconnect. This Fabric interconnect will be added to the cluster. Continue (y/n) ? y
Enter the admin password of the peer Fabric interconnect:
Connecting to peer Fabric interconnect... done
Retrieving config from peer Fabric interconnect... done
Peer Fabric interconnect Mgmt0 IP Address: 10.0.0.4
Peer Fabric interconnect Mgmt0 IP Netmask: 255.255.255.0
Cluster IP address : 10.0.0.3
Physical Switch Mgmt0 IPv4 address : 10.0.0.5
Apply and save the configuration (select 'no' if you want to re-enter)? (yes/no): yes
Applying configuration. Please wait.
Aikas helppoa. Tuon jälkeen pääsee kiinni HTTP:llä hallintaan. Vaatii kyllä javan, uh.
Semmoinen minkä huomasin, että jos ryssii ton SITE NAMEN (kuten itse tein), niin sen saa näin korjattua:
Otetaan yhteys ssh:lla kytkimeen.
vanha-ucs1-A# scope system
vanha-ucs1-A /system # set name uusi-ucs1
vanha-ucs1-A* # commit-buffer
Ja uusi clusterin nimi (system name) on käytössä.
Ei kommentteja:
Lähetä kommentti